SQM Replication Project Update 11-04-05.

I am still close to the first attempt of conditioning the magnets but a few small things I am not yet happy with: 1/ Time to discharge the capacitor is still causing the SCR/Thyristor to latch. I am still thinking my direction here may not be right. I have briefly tested the SCR oscillator circuit with no success. This is what I need. Capacitor to discharge and to turn off the SCR with back EMF. This could be a single discharge of the capacitor but is more likely to be a discharge in oscillations other wise this does not explain the bulb in the video oscillating in brightness. 2/ Increase if possible the resonance affect at the top of the large coil, the blade is waving or oscillating but is is fairly lightly oscillating. There is a bit of a delicate balance in this setup for the conditioning. Tuning and adjusting after time will give the desired results here and I hope we get the results with the magnets after this is all done. I am thinking more and more that it will. I found these quite good articles about magnets also there is some mentions of instabilities of the magnets and that's what I think we are going after. Click Here. Something I am finding interesting is the amount of pages on the net that have been taken down when you search for "Spin wave instability magnon distribution for parallel pumping". Interesting ;o) Lucky I have a few books about this phenomena. There looks to be a trigger or a triac as was said in the video. This is interesting because I have not noticed before the wire from the AC side of the Diode Bridge to the triac or trigger.

The amount of wire pair to the conditioning coil is at the moment undecided. I can make out at least three wires if not four. How many pairs is my question? I am guessing four pairs.